W
IRING THE
S
YSTEM
NOTICE: If you do not feel comfortable with wiring your new
source unit, please see your local Authorized Rockford Fosgate
Dealer for installation.
• For safety, disconnect the negative lead from the battery prior to
beginning the installation.
1. Install the 16-Pin Power Harness by connecting the correspond-
ing wires to the electrical and audio system. Solder and heat
shrink all connections for a reliable installation. For each con-
nection, cut a 1" piece of heat shrink tubing and slide over one
of the wires. Strip each wire 3/8" then twist together and solder.
Slide the tubing over the connection and shrink the tubing with
a hot air gun until no bare wire is exposed.
2. Connect the BLACK wire to chassis ground. Prepare the chassis
ground by scraping any paint from the metal surface and thor-
oughly clean the area of all dirt and grease. Strip the end of the
wire and attach a ring connector. Fasten the wire to the chassis
using a non-anodized screw and star washer.
3. Connect the YELLOW wire to a source of co12V (for
retaining memory on user-programmed functions). Connect the
Yellow wire to a co12 volt positive source. The source
should always have +12V, even when the ignition is off and the
car is not running.
4. Connect the RED wire (Ignition) to a source of sw12V
(is on only when ignition key is in “accessory” or “run”).
Connect the RED wire to a sw12 volt positive source.
The switched signal is usually taken from the ACC (accessory)
position of the ignition. If the vehicle does not have an ACC
position, connect the wire to the switched ON position of the
ignition. The current consumption through this wire is negligible.
5. Connect the LT. BLUE wire to the “Remote Turn-On” leads of
the amplifier(s). This will turn-on the external amplifiers when
the source unit is powered on.
6. Connect the BLUE/RED wire to the “Power Antenna” lead. This
will raise a fully automatic antenna when the source unit is
powered on.
7. Connect the B+, GND and Remote Turn on Wires on the 16 pin
harness according to the Installation Reference Sheet.
– 16 –
All manuals and user guides at all-guides.com