– 17 –
8. Connect the AUX RCA Jacks to the external audio source (this
inserts the audio before the volume control on the source unit).
The maximum un-clipped input voltage this circuit can accept is
4.0V RMS.
9. *Connect the AUX Video1 and Video2 Jacks to the output of
the external video source(s).
10. Connect the Speaker Wires (if external amplifiers are not used)
to the corresponding speaker leads by soldering and heat shrink-
ing all connections for a reliable installation. If only one pair of
speakers is utilized in the system, use only the FRONT speaker
leads and heat shrink the unused REAR leads to prevent from
shorting out. Be sure to maintain speaker polarity. DO NOT
chassis ground any speaker leads as unstable operation may
result.
11. Install the Preamp Output Harness (if external amplifiers will
be used) by plugging the RCA cables into the corresponding
extension RCAs that feed the input of the amplifiers. Be sure to
route the signal cables away from any high current wires to pre-
vent coupling noise from radiated electrical fields into the audio
signal.
The FRONT RCAs connect to the Front speaker's amplifier.
The REAR RCAs connect to the Rear speaker's amplifier.
The SUM RCAs connect to the Subwoofer amplifier.
The REAR SEAT RCAs connect to the Headphone jacks located
in the rear of the vehicle.
The AUX1 & AUX2* RCAs connect to the output of an auxiliary
audio source.
*The VIDEO1 & VIDEO2 RCAs connect to the output of an
auxiliary video source.
*The VIDEO OUT RCA connects to outboard video monitors.
10. Connect the CD Changer (optional) by plugging the 8-pin DIN
cable into the connector located at the rear of the source unit.
11. Connect the Antenna by plugging the antenna cable into the
connector located at the rear of the source unit. Be sure the
antenna is securely grounded to the vehicle for proper radio
reception.
*Feature available on RFX8350 & RFX8350RDS only
All manuals and user guides at all-guides.com