Thank you for purchasing this product.
●
Carefully read this Installation Manual to install the product correctly.
●
Be sure to test operation after installation has been completed.
●
Be sure to pass this Installation Manual, User’s Manual and Warranty Certificate
to customers. When passing these to customers, explain the operation method.
CAUTION
Installation Procedure
Note 3
●
Do not put your hand on, or
step on, the water shutoff valve.
* T h e p i p e m a y b u c k l e o r b e
damaged, causing water leakage.
* The wall or floor may be damaged.
●
Attach the water supply inlet of
the water shutoff valve, to prevent
the water supply hose being bent.
1
Position of Water Supply Pipe and Drain Pipe
Prepare the water supply pipe and the drain pipe.
* When water supply is on the right side, prepare the
water supply pipe symmetrically relative to the drain
pipe.
Note 7
When attaching the drain socket
to the flange, be sure to attach the
gasket to the drain socket (rear).
Note 5
Do not drop the drain socket by
mistake.
* The member may be damaged, causing water leakage.
Note 6
Be sure to attach the drain socket so
that it is parallel to the rear wall. If the
socket is angled, the toilet bowl will
also be on an angle when installed.
Wall
Drain socket
300 or more
330
280
280
100
100
300
Water supply pipe 1/2B
(supply from wall)
Drain pipe
Unit: mm
Water supply pipe 1/2B
(supply from floor)
Note 1
Be sure to observe the dimensions on the
drawing to position the water supply pipe.
Note 2
●
Insert a plug (LF-7T recommended) into
the water supply pipe and cover the
drain pipe with a vinyl bag or similar to
protect these pipes from foreign matter
until the toilet is installed.
●
Firmly secure the water supply
pipe to prevent it wobbling.
See Note 1
See Note 2
Note 4
Attach the flange so that the two
T-bolts are parallel to the wall.
3
Attaching Drain Socket
(3) Drill the pilot holes (ø11 mm, 55 mm deep) at the positions marked in step (2).
Completely remove chips, and then insert the
fl
oor securing AY bolts. Push the edge
of the rubber tube into the the hole, pull the bolt in the tube hard to expand the rubber
tube to form complete contact with the hole, and then unscrew the bolt to remove it.
Drain socket
Floor securing member
(4) Attach the gasket to the drain socket and secure these with T-bolts.
See Note 6
See Note 5
See Note 7
See Note 4
(1) Remove the open/close handle.
(2) After wall or floor work has been completed, attach
the water supply pipe and the water shutoff valve.
* When attaching the water shutoff valve to the water
supply pipe, wrap the threaded section of the pipe with
sealing tape or similar sealing material.
* When supplying water from the wall, angle the water
supply inlet of the water shutoff valve approximately 20
degrees below horizontal level. This makes water supply
hose attachment easier.
When supplying water from the floor, angle the water supply
inlet of the water shutoff valve approximately 45 degrees
toward the wall for the same purpose.
(3) After the water shutoff valve has been attached, attach the open/close handle.
* Check that the handle is at the closed position.
●
Water supply from wall
2
Attaching Water Shutoff Valve
See Note 3
Click
Positioning groove
Open/close handle
●
Water supply from floor
* Remove the open/close handle from the water shutoff valve,
and set the tool to the tool setting section (hexagonal) on
the water shutoff valve, and then tighten the valve firmly.
Approx. 20 deg.
Water shutoff valve
Seal tape
Water supply pipe
Water supply inlet
Floor
Tool setting section
(hexagonal)
Water shutoff valve
Seal tape
Water supply inlet
Approx. 45 deg.
Water supply pipe
Water supply pipe
Wall
Tool setting section
(hexagonal)
Open/close handle
Open/close handle
(1) Attach the flange to the drain pipe, and set the T-bolts upside down.
(2) Position the drain socket and the floor securing member temporarily, and mark
the positions of the pilot holes for the floor securing AY bolts (5 locations).
Drain socket
Washer
Floor securing AY bolt
Flange
Flange nut
Washer
Gasket
Flange
Gasket
Drain outlet
Flange
Tile
Mortar
Concrete
Pull up
Expand rubber tube
(5) Secure the drain socket with the
fl
oor securing AY bolts (5 locations).
Floor securing pilot hole
Rear
Rubber tube
Parallel
E-Bidet.ru -
официальный
дилер
Roca Lumen Avant
в
РФ
(http://e-bidet.ru)
E-Bidet.ru -
официальный
дилер
Roca Lumen Avant
в
РФ
(http://e-bidet.ru)
