Robus Black Star 10 Comfort, Руководство пользователя

Страница: 20 / 26

Robus Energy Ltd
20 of 26
MCS 0001RE Issue 2.1 March 2014
Cleaning of the burner / boiler.
Cleaning should be carried out regularly and as needed. There is a big difference in the frequency of
maintenance required from system to system. The setup, adjustment, and wood pellet quality play
an important role on how frequent maintenance should be performed.
The table is only a suggestion and applies only to the BS1016, BS2030 and BS4050 boilers!
Always use personal protective equipment. Dust, ash and soot are hazardous to health!
Turn off the controller and allow the boiler to cool for approx. 5 min. Once the burner is completely
turned off, it is ready for cleaning. Unplug the burner, remove the shield, drop shaft, and detach the
burner from the boiler so work can be easily performed.
Boiler.
All surfaces inside the boiler must be brushed clean from any deposits and the ash can must be
emptied. When empting the ash can, pay special attention to any build-up of ash in the rear smoke
chamber and flue, since the Chimney Sweeper may not always be removing the ash from the
chimney flue.
Never dispose of hot ashes in the trash, but let it cool in a metal bucket. Hot ashes can re-ignite.
Burner head.
Remove any ash or cinders from the grate. Remove any pellet remnants under the burner grate.
Wipe the photo sensor clean. When re-inserting the photo sensor, ensure that the sensor points
towards the combustion grate. Ensure that there is nothing lodged in the fan and that it can rotate
freely.
Hopper.
Since pellets naturally contain dust, you should periodically empty the hopper completely. The more
dust there is present in the hopper the less the auger will dispense, and the more unstable the
dosing. The boiler will go out of adjustment with greater risk of downtime. How often one should
empty the hopper depends greatly on the quality of the pellets you use.
Put 1litre of cooking oil or similar into the hopper each time it is emptied (poured over the last
pellets) and the hopper will automatically empty the sawdust.
Start-up after cleaning.
Once the pellet boiler is reassembled, turn on the controller and the burner will start itself up.
Remember to reattach the shield so that the temperature reading on the burner is correct.