Robur Roburbox100, Инструкция по установке и эксплуатации

Страница: 63 / 84

USER INTERFACE section
Ed. 06/2014 – FW version 1.002 57
•
Table 17 shows board parameters for
DHW0 service
on RB100 interface.
MENU 1 – PARAMETERS VIEW
DHW0 SERVICE PARAMETERS
PARAMETER PARAMETER DESCRIPTION VALUE DESCRIPTION
ACTIVE DHW0 SERVICE (I,A)
0. inactive
1. active
DDC ID THE DHW0 REQUEST
IS SENT TO
(1)
(I,A)
960 to 1023
TYPE OF GROUP THE
REQUEST COMES FROM
(2)
(I,A)
0. basic group
1. separable group
TYPE OF SETPOINT INPUT
FOR DHW0 SERVICE
(3)
(I, A)
0. analogue 0-10V
1. digital with remote setpoint
2. digital with local setpoint
TEMPERATURE
CORRESPONDING TO MIN
SETPOINT FOR DHW0
SERVICE
(4)
(I, A)
0 °C to +90 °C
TEMPERATURE
CORRESPONDING TO MAX
SETPOINT FOR DHW0
SERVICE
(5)
(I, A)
0 °C to +90 °C
MINIMUM TEMPERATURE
CORRESPONDING TO OFF
REQUEST FOR DHW0
SERVICE
(6)
(I, A)
0 °C to +90 °C
SETPOINT RESOLUTION FOR
DHW0 SERVICE
(7)
(I, A)
0 °C to +2 °C
LOCAL SETPOINT FOR DHW0
SERVICE DIGITAL INPUT
(8)
(I, A)
0 °C to +90 °C
Table 17
Parameters of menu 1: board parameters for DHW0 service
(1) DIGITAL DIRECT CONTROLLER [DDC] ID THE REQUEST IS SENT TO
(2) THIS PARAMETER DEFINES THE GROUP THE REQUEST IS TO BE SENT TO (BASIC GROUP/SEPARABLE GROUP)
(3) INPUT CONFIGURATION
(4) ONLY USED FOR ANALOGUE INPUT. IT CORRESPONDS TO TEMPERATURE EQUAL TO 0V
(5) ONLY USED FOR ANALOGUE INPUT. IT CORRESPONDS TO TEMPERATURE EQUAL TO 10V
(6) ONLY USED FOR ANALOGUE INPUT. UNDER THIS TEMPERATURE, OFF REQUEST IS SENT (THE ON REQUEST, WITH
PROPER SETPOINT, IS SENT WHEN INPUT VOLTAGE CORRESPONDS TO A TEMPERATURE VALUE BETWEEN THIS
PARAMETER VALUE AND VALUE OF PARAMETER 105)
(7) ONLY USED FOR ANALOGUE INPUT. RESOLUTION APPLIED FOR SENDING SETPOINT VALUE TO DDC
(8) ONLY USED FOR DIGITAL INPUT WITH LOCAL SETPOINT. IT CORRESPONDS TO SETPOINT SENT TO DDC WHEN DHW0
SERVICE IS REQUIRED
If value 0.0°C is set up for parameter 107, the system applies the minimum
resolution used for temperatures (0.1°C).