Robur B15 Generators Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 29 / 34

Installation, user and maintenance manual – Series B15 Generators
29
4 Use And oPeRAtIon
4�1 sWItCHInG on And sWItCHInG off
The first start up must be done by professionally qualified personnel.
Before starting up the generator, have it checked by professionally qualified personnel:
the electricity and gas mains specifications must correspond to the specifications •
on the nameplate;
the calibration must be compatible with the generator’s power rating;
•
the fumes exhaust tubes are operational; •
the combustion air and fumes exhaust must be in accordance with established •
legislation.
WInteR Mode
To activate HEATING mode, proceed as follows:
You will need: the appliance connected to the power/gas supply.
Set the room thermostat to its maximum. 1.
Check that the gas valve is open. 2.
Power up the appliance with the master power switch. 3.
Set button "A" (summer/winter button) to 4. Winter ("snowflake" ICON; detail "1" - Fig-
ure 4.1
→
29).
After the pre-plunge time (around 40 seconds), the gas solenoid valve opens and 5.
the burner ignites.
The appliance’s controller keeps the valve open so long as it detects the flame.
6.
If it does not, the controller locks out the appliance and turns on the lockout led 7.
on the reset button "B" (detail "3" - Figure 4.1
→
29): if this occurs, press the reset
button "B".
Once he burner has ignited, set the room thermostat to the desired value.
8.
figure 4�1
Wall panel.
LeGend
A
summer/winter button
B reset button
1 "snowflake" icon (winter position)
[for heating operation]
2 "sun" icon (summer position)
[for ventilation operation only]
3 lock-out led
A B
1
2
3
sWItCHInG off
To switch off the appliance, proceed as follows:
You will need: the appliance operating (switched on).