Roborock E5, Руководство пользователя

Страница: 31 / 216

31
Parameters
CDZ14RR or CDZ15RR
151×130×98mm
28W
100-240 VAC
20VDC 1.2A
50-60Hz
14.4V/5200mAh lithium battery
Troubleshooting
If an error occurs during the cleanup, the Power Indicator will flash red quickly, and a voice alert will play. Refer to the table below for
resolution options.
Error 2: Clean and lightly tap the
Bumper.
The Bumper is stuck. Lightly and repeatedly tap the Bumper to remove any foreign
matter. If no foreign matter is found, move the machine to a new location and restart.
Error 3: Move the robot closer to its
starting location and restart.
The wheels are suspended. Move the robot closer to its starting location and try again.
Error 4: Wipe the Cliff Sensors and
move the robot closer to where it left
and restart.
The wheels are suspended. Move the robot closer to where it left and restart. This error
may also be caused by dirty Cliff Sensors. Wipe the Cliff Sensors and retry.
Error Solution
Error 5: Remove the Main Brush and
clean the brush and bearings.
The Main Brush may have become entangled with debris. Remove and clean the Main
Brush and its bearing.
Error 6: Remove and clean the Side Brush. The Side Brush may be entangled with debris. Remove and clean it.
Error 7: Remove any debris entangled
in the main brush. Move the robot
closer to where it left and restart.
The Main Wheels may be jammed. Remove and clean them.
Error 8: Clear away any obstacles
around the robot.
The robot may be stuck. Clear any obstacles around it.
Error 9: Install the Dustbin and Filter.
Reinstall the Dustbin and Filter. Check that they are installed properly. If the problem
persists, try replacing the Filter.