36
Robomow RS models
Message
Displayed
Probable Cause/Event
Corrective/User Action
Start elsewhere
- Drive wheel motors have been working under
a severe load during automatic or manual
operation.
- Check to insure the mower is not stuck, allowing the
drive wheels to slip.
- Check the ground around the mower for holes or
indentations. Fill with dirt and level off.
- Check if the drive wheels are free to rotate and nothing
blocks them.
- Remove the mower away from this particular location
and restart operation.
Start inside
- Automatic operation is initiated while the robot
is placed out of the Perimeter Wire loop.
- Place the mower inside the lawn and press the
button.
Stuck in place
- Robomow got stuck in place. It cannot continue
driving.
- Check the ground for holes or indentions, where the
mower has stopped and fill it with dirt and level off –
especially in the area close to the perimeter, where the
Robomow turns in place.
- Robomow has difficulty to turn in place
because the front wheel is blocked by a hole
or indentation. It caused the mower to turn in
place without detecting wire or bumper.
- Verify that the area is not too steep.
- Work mainly in dry conditions.
- Check if the Perimeter Wire is not too close to the edge
– remove if required.
- Verify that the mowing deck is not set too low.
Switch off
before lifting
- The user carries Robomow manually while the
Safety Switch is
On
.
- Switch
Off
the Safety Switch before carrying Robomow.
Waiting for
Signal…
- Robomow has stopped the operation: it does
not detect a signal.
- Check the power to the Power Box.
- It may be an electrical power interruption. There is no
need to do anything. Robomow will renew operation as
soon as power is back.
-
תועמשמ שי םא ,ךרוצ ןיא םא
–
7.3 Other Problems
Problem
Encountered
Probable Cause/Event
Corrective/User Action
Poor quality of
mowing
- Dull blade
- Switch between the two blades to use the sharp side,
which was not use yet.
- Replace blades.
- Grass is too high in relation to the set cutting
height.
- It is recommended to cut less than a 1/3 of the green part
of the grass.
- Set the cutting height to a higher position and then
successively lower.
- If it is the fast growing season – use Robomow more
frequently to maintain the lawn (see Section 4.3.2
Increase / Decrease Operations
).
- Grass is wet.
- Accumulation of grass clippings around the
blade.
- For best cut, operate Robomow when the grass is dry. It is
recommended no to mow in the early morning hours.
- Switch off the Safety Switch and use heavy gloves to
clean and remove the grass clippings.
Mower doesn›t
find the Base
Station or the
mower acquires
adjacent wire while
following the wire
in Near Wire Follow
mode
- There is a Perimeter Island / Obstacle or
Narrow Passage that prevents the mower to
complete its drive towards the Base Station
in Near Wire Follow mode.
- Reduce the
Near Wire Follow
Distance in the menu from
the default
7
.
