10
Robomow RS models
P
Lay the Template on the ground at the entrance to the Narrow
Pass:
)
The
arrow points towards the entrance to the
Narrow Pass, in the direction of the Sub-Zone.
)
Insert by hand (half-way in) 7 pegs into the 7 holes
numbered 1 – 7 .
P
Lift the Template up so the pegs are left loosely stuck in the
ground.
P
Lay the Perimeter Wire through the four right-side pegs numbered
1 – 4
)
Hold the wire around each peg 1 , 2 , 3 , 4 while
driving the peg all the way into the ground.
)
Leave pegs 5 – 7 standing half-way out. They will be
connected to the wire later.
P
Continue laying the Perimeter Wire through the pass towards
the Sub-Zone:
)
Straight line at a minimum distance of 45 cm (1.5 ft.) from
the pass right side edge.
)
Pause at the end of the Pass in order to set the other end
of the Narrow Pass.
P
There should be a 40 cm (1.3 ft.) distance between the Sub-
Zone Perimeter Wire and the pass exit.
P
Turn the Template and lay it on the ground at the entrance to
the Sub-Zone:
)
The
arrow points towards the Sub-Zone.
)
Insert by hand (half-way in) 7 pegs into the 7 holes
numbered 1 – 7.
P
Lift the Template up so the pegs are left loosely stuck in the
ground.
P
Lay the Perimeter Wire through the three right side pegs
numbered 1 – 3
)
Hold the wire around each peg 1, 2, 3 while driving the
peg all the way into the ground.
B
1
STAR
T
END
2
4
1
3
5
6
7
2
4
1
3
5
6
7
B
1
STAR
T
END
2
4
1
3
5
6
7
2
4
1
3
5
6
7
1
B
1
B
1
END
STAR
T
2
4
1
3
5
6
7
2
4
1
3
5
6
7
1
B
1
Lay the Template
Turn the Template and lay it on the ground
Insert
1
–
7
pegs
Insert 1 – 7
pegs
Lay Perimeter Wire
through
1
–
4
pegs
Lay Perimeter Wire through
1 – 3
pegs
Starting the Sub-Zone Passage setup
Main Zone
Main Zone
Main Zone
Main Zone
Main Zone
Sub-Zone
Sub-Zone
Sub-Zone
Sub-Zone
Sub-Zone
