Robomow Tuscania 200, Руководство пользователя, Страница: 67 / 214

EN
25
Chapter 3 – Operation and Charging
3.1 Edge Mowing
The first mowing chore for Robomow is mowing the edge. Edge is the outer perimeter of the active
zone Robomow is working within. This is essential where you placed your perimeter wire in the
wire set-up.
Edge mowing provides a clean even cut around the perimeter and helps to minimize the amount of
trimming along walls and other obstacles.
Edge Operation –
- Place Robomow inside the lawn, switch on the Perimeter Switch on and press the ‘GO’ button
once;
- Robomow will automatically find the edge (perimeter). It will now begin mowing the edge,
completing one to two complete passes around the perimeter and then turn into the lawn to mow
the inner area of the lawn;
-
It will then drive into the lawn and begin what is called the scanning process (see paragraph 3.2).
3.2 Scanning (Mowing of the inner area)
The scanning process is simply a process whereby Robomow is moving across your lawn while it
is mowing.
Robomow’s movement pattern is irregular with combination of parallel lines in narrow passes. Keep
in mind that the Robomow will not mow all the grass on its first pass; in fact it will leave uncut grass
in between many of the passes it makes. This is expected and is entirely normal. These uncut
areas will be cut on subsequent passes of the Robomow across the lawn. Just like a dishwasher,
wait until the job is finished before you can appreciate the results.
Robomow will continue to run for the amount of time selected or for the default
‘MAX’ time, which
is generally 2.5 hours, depending on grass type and condition.
3.3 Skipping Edge Mowing
Robomow provides a means that will allow you to skip the edge mowing process and start directly
with the scanning (mowing) process. In order to do this, simply press the
‘GO’ button twice at the
initial startup of the mower. Pressing ‘GO’ the second time immediately following the first press will
tell the mower to skip mowing the edge.
3.4 Operation
x
Robomow cannot operate unless the Perimeter Switch is turned on. Press the on/off button to
turn on the switch. To verify switch operation, there is a green LED located next to the button that
will flash when operating properly. If an intermittent beeping is heard shortly after turning the
switch on, there is a problem of cut wire or poor wire splicing (refer to chapter 4 – Text messages
and Troubleshooting for further help). Look to see which of the red LED is flashing to identify the
problem (refer to figure 1.19). You must correct the problem before Robomow can operate
automatically.
x
Place the mower inside the active perimeter.
x
Press the ‘Down’ scroll arrow to receive the display of the zone to be mowed (Zone A or B) and
press the ‘GO’ button. In a case where you have forgotten to turn on the Perimeter Switch, a ‘No
wire signal’ message will be displayed, reminding you to turn the switch on.
3.5 Completing the Operation
ƒ When Robomow has operated the allotted time, it will simply stop in the lawn, waiting for you to
drive it back to the Base Station. The LCD will display a ‘
Recharge battery’
message if the
mowing time is set to ‘ MAX ’ or ‘ Time completed’ if the mowing time has been set to any time
other than ‘ MAX ’.
ƒ If Robomow has completed its mowing and it is more than 15 minutes before you arrive to move
it, the LCD screen will be blank. Robomow will shut itself down into a sleep mode after 15
minutes of inactivity at all times. This is an energy saving feature. Pressing the
‘GO’ button will
wake it up and display the message that was on the LCD when it went into sleep mode.