Robland T-120 L, Руководство пользователя

Страница: 6 / 50

- Do not slow dawn the tool by lateral pressure against the body
- Do not work without the necessary safety guard
Operator’s place at the workpost
For all executions with the spindle fence, and for use of the ring guard fence:
When tenoning:
Normal and prohibited use
With the T 120 spindle-moulder the operator can mould and form straight and curved pieces, and almost any
task in woodworking can be executed in massive wood, wood-based panels and certain plastics.
It is strictly forbidden to process ferrous and non-ferrous materials. It is also forbidden to make changes to the
machine in order to execute other tasks than those described above.
Moulder-shaper
The shaper assembly is assigned to the following tasks and equipped with protective devices. Other tasks than
listed below are therefore prohibited.
NORMAL USE
- mould and form straight and curved pieces on the vertical spindle;
- shaping of curved work pieces using a ring guard fence;
- mortising, tenoning and panel edge shaping using corresponding safety devices.
PROHIBITED USE
The following tasks are prohibited on the moulder-shaper unit:
- down-cut shaping, i.e. When feed and tool rotation direction is the same;
- slotting with saw blades;
- using tool diameters that are not adapted to the spindle by using reducing sleeves;
- using larger tool diameters and higher speeds than shown in the diameter-speed diagram;
- the use of ferrous and non-ferrous.
REMAINING RISKS
Spindle shapers are one of the main causes of injuries in woodworking. Nearly all accidents result in hand injuries.
Due to contact with the rotating tool when the work piece is fed by hand, a kickback occurs.
The main danger areas on the shaper-moulder are:
- the moving machine and tool parts;
6