Installation
1. Pre drill pilot hole 3mm diameter at dimensions C and B.
B=305mm and C=220mm.
2. Loosely fix the mounting screw and 2 x washer in position, check with a spirit level across the
washers to ensure they are level.
3. Mark the position of the decorative chimney at the ceiling and wall. Cut the cornice moulding away if
required, to enable the chimney to fit flush against the wall and ceiling.
4. Mark and cut out the hole in the ceiling / wall to fit the ducting. (170mm dia.) This is positioned
centrally above the canopy hood and 85mm from the wall. (For ceiling option)
5. Using the screws supplied, fix the chimney bracket to the wall, 100mm below the ceiling
checking that it is aligned with the hood.
6. Remove the protective plastic covering from all parts including the filters. Fit the canopy hood on the
mounting screws, tighten screws. Plug in the power cord to the supply and check the function of the
canopy hood. Connect and secure the ducting (use duct tape if required).
7.
Assemble the top chimney to the chimney bracket and fix using the screws supplied, then assemble
the bottom chimney to the canopy hood and fit into the glass recess.
8. Remove transport tape that holds the oil cup in place under the motor unit and fit the filters.
Cleaning and maintenance
Particular care must be taken with the aluminium filters which must be periodically cleaned (at least every
two months). Remove the grease filters and wash them either by hand using hot soapy water or in the
dishwasher using mild detergent.
Note
- some discolouration of the frame may occur.
Caution:
Never use abrasive or oil based liquid cleaners.
To clean the stainless steel and glass components of the appliance use mild detergent and warm water. In
areas of high humidity and coastal environments cleaning should be carried out frequently.
In the case of charcoal filters, these are disposable items and it is recommended that these be replaced
every 2-4 months depending on the use of the canopy hood.
Halogen bulb replacement
1. Switch off the power to the canopy hood and allow the bulb to cool.
2. Use a small bladed screwdriver to prise off the light cover, taking care not to
damage the surrounding material.
3. Use a cloth to remove the bulb.
4. Replace with a new bulb using a cloth.
5. Snap the cover back into place
Do not touch the bulb
with fingers
.
Optional accessories:
Charcoal filter
2517
Halogen 10W bulb
114313
Chimney extension 10ft
2192
Chimney extension 12ft
2193
For other accessories, parts and service, please contact your local supplier (Refer to the Warranty
Certificate).
