Pre-Installation -
continued
Contents of packaging:
Typical equipment required:
1 x rangehood
electric drill and screwdriver
1 x packet of fasteners and wall plugs
tape measure and spirit level
2 x chimney pieces (upper and lower)
step ladder
1 x chimney bracket
duct tape (if ducting)
1 x Installation and Operating Instructions
jig saw (if ducting)
ladder (if ducting)
Ducting Options
The method of ducting should be carefully considered before installing the rangehood. The guide below recommends
the ducting components to use for all common ducting configurations - through the top of the home (for the roof and
soffit) and through the rear of the home. 150mm round ducting should be used in conjunction with this model
rangehood. Alternatively this rangehood can be operated in recirculation mode (Pg.6 Recirculation mode).
The highlighted area in the table below gives the recommended Uniduct item numbers for different
mounting and outlet options.
Extra lengths and/or bends may be required, depending on the length required and whether there is any structural
material in the way, e.g. rafters.
Please note that this chart is designed as a guide. Please consult Robinhood customer services if unsure.
For NZ phone 0800 760 667 or www.robinhood.co.nz. For AUS phone 1800 648 556 or www.robinhood.com.au.
