Preliminary Instructions
Ascertain from the user the
DESIRED HEIGHT
of the Ironing Board when in
the opened position. We recommend an ironing surface height of 830mm
above the floor for an average adult. To obtain this surface height, the bottom
external edge of the cabinet must be 640mm above the floor.
Installation Instructions
Step 1
Step 2
The ROBINHOOD Ironing Centre can
be mounted in two ways (Fig1)
a)
Surface Mount
- make sure solid
timber studs or mounting points are
in a suitable position for the mounting
of the Ironing Centre. Drill and fasten
through the back of the wooden panel
only to the Mounting Points (A) with
the 4 screws supplied (it may be
necessary to purchase different
length screws for correct fitting, or
use wall anchors if unit is to be
mounted to a solid wall).
b)
Recessed Mount
- cut the opening
in wall by reference to the
Specification Diagram, allowing for
the cut out when being inserted into
the wall. Make sure solid timber studs
or mounting points are positioned
flush with each side of the wall cut
out opening, drill and fasten through
the sides of the cabinet into the solid
studs (B) with the 4 screws supplied.
To seal gaps between opening of
wall and cabinet, use skirting
available from your local hardware
store.
NOTE
: It is important that the Ironing
Centre be installed vertically in the
wall, check with a spirit level on the
front and side faces of the unit.)
Mounting Options
Step 3
Connecting the Centre to Electric Power
The Ironing Centre’s 3 pin plug and lead can be easily plugged into the nearest
wall socket, or can be hard wired by an electrician.
Step 4
Ironing Centre Assembly Instructions
NOTE: DOOR MAY BE HINGED TO LEFT OR RIGHT SIDE OF CABINET
(Depending
on user’s preference)
ALL ILLUSTRATIONS SHOWN ARE FOR LEFT SIDE HINGING
Locate and fix hinge brackets to cabinet with 2 large
screws provided.
Fix magnetic door catch to the bottom of the cabinet
on the opposite side to the door hinges (Fig.3) with
the screws provided into the pre drilled holes.
Fix door to top and bottom brackets as shown, (Fig.2)
with screws provided into pre-drilled holes. To ensure
door alignment, adjust top or bottom hinges. Lock hinges
in place with 3rd screw provided.
Fix door hook in desired position using 10mm long self
tapping screws provided. Check that hook is clear of
ironing board in closed position.
Fix magnetic catch plate to bottom of door with
countersunk screw provided into pre-drilled hole.
Check for correct function and adjust door catch
if necessary.
STORED POSITION
BOARD RETAINER
T-BAR
F i g . 2
A. SURFACE MOUNT
B. RECESSED
Timber
( A )
( B )
( A )
SCREWS
SCREWS
Step 2
F i g . 1
