Robin America EY15-3, Руководство по обслуживанию

Страница: 44 / 62

- 41 -
Fig. 10-12
Boss of real
Fig. 10-13
Fig. 10-14
Ratchet hole
Within this area
Ratchet
Claw
Receiving
area of
the Reel
Inner end
of spring
Hook of Case
-2: Hold up the real gradually and slowly, and remove it from the case.
-3: If the spiral spring in the reel likes to jump out of the reel, stop the procedure and push the
reel against the case to redo the step of section (3)-1 and (3)-2.
WARNING
Since the spiral spring is set in the reel, do not drop or shake it. Put it on a flat place.
Disassembly is completed.
WARNING
Before starting the assembly, make sure to wear the protective glasses.
10-2-2 ASSEMBLY STEPS
(1) Setting the reel into the case.
-1: Peep at the boss of reel to check the inner
end of the spring.
-2: Hook the inner end of spring to the hook of
case and put the reel into the case.
(Fig.10-12)
(2) Assemble the component parts.
-1: Put the ratchet in the reel so that the re-
ceiving area of the reel is within the area
illustrated in Fig.10-13.
-2: Assemble the friction spring to the shaft in
the case.
-3: Insert the legs of friction plate (2 places) in
ratchet holes. (Fig.10-14)
(3) Tighten the center screw. (2 people required
for this step.)
-1: Adjust the tip of center shaft to the hole of
friction plate and compress the friction
spring by pushing the friction plate with your
fingers.
-2: Tighten the center screw counterclockwise
(as it is reverse screw).
WARNING
Wear work gloves during operation to avoid a
possible injury by a sharp edge of the friction
plate.
Leg of
Friction plate