Robin America EY15-3, Руководство по обслуживанию, Страница: 41 / 62

- 38 -
Fig. 10-5
Fig. 10-6
Fig. 10-7
Fig. 10-8
Set screw
Ratchet guide
Friction Spring
About 200mm from the reel
LATCHET GUIDE SUB-ASSEMBLY
-2: Holding the latchet position, mount the
latchet-guide sub-assembly. (Fig.10-5)
(3) Tightening the set-screw.
-1: Push the latchet-guide lightly by hand so
that the latchet guide won’t move and
tighten the set-screw.
(4) Storing the spring-power.
-1: Hold the case tightly and wind up the reel
counter-clockwise 6 times by both hands.
-2: Hold the reel at the position where the rope
hole of the reel and the rope guide make a
straight line. (Fig.10-6)
WARNING
The spring power is at its maximum when the
reel is being wound. Do not put off your hand
nor loosen the pressure of your finger unin-
tentionally.
(5) Setting the rope. (2 people required)
-1: Pass the rope end through the rope guide
and the rope hole of the reel and pull the
end about 20cm out of the reel. (Fig.10-6)
-2: Fasten the rope end. (Fig.10-7)
-3: Put the rope end into the reel, whereby
make sure that the rope end will not float.
(Fig.10-8)
-4: Hold the rope firmly with the hand at the
position about 50 cm from the rope guide
and keep the rope slightly pull so that the
rope will not be wound in.
-5: Release the hand of the reel gently and wind
the rope slowly by the winding power of the
spring until the knob reaches the rope
guide.
Assembly is completed.
*The disassembly and the reassembly have been
completed, however carry out the following to
check if the necessary components have surely
been assembled.
About 20mm