If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
4
Using the clock radio for the
fi
rst time
1. Place your clock radio on a
fl
at surface.
2. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
3. Insert the adaptor plug into the DC socket located on the rear of your
clock radio. Plug the adaptor into a standard 13 amp mains socket
outlet. The display will show 'Roberts' for a few seconds and then the
display will show 'Clock not set' and the clock digits will
fl
ash. The
clock hands will then move to 12:00.
4. Press and release the
On / Off
button.The radio will scan for DAB
signals and if a DAB signal is found it will then set the current time and
date. (This will be displayed if you return the clock radio to standby).
The clock hands will then move to show the correct time.
5. If no stations are found, 'Clock not set' will be displayed. It may be
necessary to relocate your clock radio to a position giving better
reception. You should then carry out a scan to
fi
nd stations as described
on page 8.
• IMPORTANT:
The mains adaptor is used as the means of connecting
the clock radio to the mains supply. The mains socket used
for the clock radio must remain accessible during normal use. In order
to disconnect the radio from the mains completely, the mains
adaptor should be removed from the mains socket outlet
completely.
Characters appearing on the LCD display indicate that the clock radio is
connected to and powered from the mains supply.
09:30:08
1-5-2012
00:00:00
Clock not set
4
Scanning... 24
