Roberts Gorden Blackheat BH15ST, Инструкция по установке, эксплуатации и обслуживанию

Страница: 61 / 84

SECTION 13: W
IRING
55 of 75
SECTION 13: WIRING
Connect to the electrical s u pply u sing a 3 pin pl u g v ia a
locally mo u nted do u ble pole f u sed s w itch ha v ing a
minim u m disconnection of 3 mm on each pole. This
s w itch sho u ld be f u sed to 3 amps. The b u rner is f u sed at
2 amps. There are no control connections in the standard
b
u rner. Control is affected by interr u ption of the main
po w er inlet.
See Page 55, Section 13.1 through Page 57,
Section 13.4
for the external w iring details for the single-
b u rner, do u ble linear and m u ltib u rner heater systems.
All w iring m u st comply w ith c u rrent w iring reg u lations and
any local reg u lations w hich may apply. Al w ays s w itch off
the s u pply to the b u rner and disconnect by remo v ing the
pl u g before remo v ing the b u rner side panel.
For U-T u be heaters, fan w ill pl u g directly into b u rner pack.
For Linear and do u ble linear heaters, an interconnecting
cable w ill be req u ired bet w een the fan pl u g and b u rner
socket. This cable shall be three core, s u itable for c u rrent
load of 10A and shall be installed clear of appliance in
accordance
w ith Section 3 , Page 5 through Page 9 data.
The req u ired pl u g and socket for this cable are s u pplied
w ith the appliance; cable is not incl u ded.
All electrical w iring m u st be carried o u t in accordance w ith
AS/NZS 3000-2007 as amended.
13.1 Typical External Wirin g Dia g ram (Linear or U-Tube)
DANGER
Electrical Shock Hazard
Disconnect electric before service.
Heater must be properly grounded.
Failure to follow these instructions can result
in death or electrical shock.
230 V
1 Ø
50 Hz
Burner 1
L
N
Earth
Fan 1
Earth
N
L
Burner 2
Fan 2
Burner 3
Fan 3
Controller or
Thermostat