Section A - 11
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle - phone: +33 (0)3.44.26.51.89 - fax: +33 (0)3.44.26.90.79 - www.robertjuliat.fr
Robert Juliat r
eserve the right to change or alter any of the items detailed on this page, to incr
ease or impr
ove manufacturing
techniques without prior notice.
TECHNICAL FILE
1800W MSR FOLLOWSPOTS
FLO / VICTOR
ADMISSIBLE LAMPS :
PHILIPS: MSR 1800 DE
Manufacturer's recommendations:
• Read attentively the manufacturer's instructions.
• Positioning of the lamp and connecting the power supply require great care. To make sure there is a good
conduction of current, the mechanical support and the electrical connections must be free form dirt and corrosion.
The clamps and brackets must be checked whenever the lighting unit has been transported.
• The lamp emits ultraviolet radiation. Direct exposure can be harmful to your health.
• It is recommended to avoid air draughts, also avoid exposing the lighting unit to bad weather.
• Use only when bulb in place
Technical characteristics:
User's precautions:
• The lamplife, as given by the manufacturer, is a theoretic lamplife duration as "in laboratory conditions",
a cycle based on 3 hours on / 1 hour off. Briefer cycles reduce the duration of the lamplife.
• In operating conditions, it is uncommon, for the lamp to still be fully efficient after 200 to 300 hours.
Its efficiency can decrease by 30%.
• Premature wearing of lamp under performing conditions is mainly due to frequent switching on. Better leave
the lamp on, through the performance, rather than switching it on repeatedly. ( The lamplife is reduced about
1 hour, each time the lamp is switched on ). It is advised to wait for 10 minutes before switching on again.
(This extends the duration of the lamp.)
New lamp:
• To achieve a good ionization of a new lamp, when using it for the first time, it is recommended to leave it on
for a few hours.
• Preserve carefully the guarantee slip of the lamp, as it may be asked for in the event of a dispute.
Thank you.
Nominal absorbed voltage.............................................................................1800 W
Voltage use: .............................................. (European standard) 230/245 Volts 50Hz
Voltage use: ............................................(North American standard) 208 Volts 60Hz
Minimum voltage of the power supply .............................................................198 V
(Below this charge = possible ignition failure).
Voltage at the terminals of the lamp .................................................................100 V
Amperage through the lamp.............................................................................. 20 A
Luminous flux .......................................................................................... 145 000 lm
Luminous efficacy........................................................................................ 80 lm/W
Colour temperature ................................................................................ 6000 Kelvin
Base......................................................................................................... SFa 15,5-6
Manufacturer’s rated life ............................................................................750 hours
Содержание Victor 1159
Страница 2: ...ii NOTES...
