Robe ROBIN ParFect 100 SmartWhite, Руководство пользователя

Страница: 19 / 28

19
puts, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected. Up to 32 fixtures can be
interconnected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
Ω
resistor
between Signal (–) and Signal (+) into a 5-pin XLR-plug and plug it in the DMX-output of the last fixture.
6. Control menu
The ParFect 100 is equipped with 2-row LCD display which allows to set the fixture´s behaviour according to
your needs, obtain information on its operation, test its various parts and lastly program it, if it has to be used
in a stand-alone mode.
Control panel:
[ESCAPE] button used to leave the menu without saving changes.
[NEXT] , [PREV] buttons for moving between menu items and for value adjusting.
[ENTER] button used to enter the selected menu (menu item) and to confirm adjusted value.
After switching the fixture on, display shows current DMX address.
6.1 Addressing and master/slave setting (DMXA)
Set DMXA - Use this menu item to set the DMX start address of the fixture, which is defined as the first channel
from which the ParFect 100 will respond to the controller.
If you set, for example, the address 18, the ParFect 100 will use channels 18 - 34 for control (if Mode 1 is
selected).
Please, be sure that you do not have any overlapping channels in order to control each ParFect 100 correctly
and independently from any other fixture on the DMX data link.
If there is no data received at the DMX input, the display will start to flash "0001” with actually stored DMX address.
DMX Pres - DMX preset . Use the menu to select desired channel mode.
Mode 1 - 9 control channels (default)
Mode 2 - 6 control channels
Mode 3 - 4 control channels
Mode 4 - 17 control channels
Mode 5 - 22 control channels (compatible to the LEDBeam 100 SW, mode 1)
Mast/Sla - Use this menu item to set the fixture as a master or slave.
Master - The fixture will behave as the master and can play one of ten programs
( Prog 1 - Prog 9, All )
Slave - The fixture will behave as the slave and can play either master´s program
( Play Master ) or its respective program ( Play Slave ).
6.2 Fixture information (Info)
Pon Time - Power on time . Select this menu to read the number of fixture operation hours.
Total - The item shows the total number of the operation hours since
the ParFect 100 has been fabricated.
Reset - The item shows the number of the operation hours that the
ParFect 100 has been powered on since the counter was last reset.
In order to reset this counter to 0, press and hold both [NEXT] and [PREV] buttons and the
[Enter] button at the same time.