Robe ROBIN ParFect 100 SmartWhite, Руководство пользователя

Страница: 20 / 28

20
DMX In - DMX readout. The menu is used to read DMX values of each channel received by the fixture.
Temp - Temperature . The menu shows temperature in the LED module.
Current - A current temperature of the LED module.
Highest - A maximum temperature of the the LED module since the fixture has
been fabricated.
High Res - A maximum temperature of the the LED module since the counter
was last reset.
In order to reset this counter, press and hold both [NEXT] and [PREV] buttons and the
[Enter] button at the same time.
Sw Ver - Software versions . Select this item to read the software version of the fixture modules.
IC-1 - A display processor.
IC-2 - LED control processor.
6.3 Personality (Pers)
DMX Pres - DMX preset . Use the menu to select desired channel mode.
Mode 1 - 9 control channels (default)
Mode 2 - 6 control channels
Mode 3 - 4 control channels
Mode 4 - 17 control channels
Mode 5 - 22 control channels (compatible to the LEDBeam 100 SW, mode 1)
Display - Display adjusting . This menu allows you to adjust the display behaviour.
Turn - This function turns the display by 180°.
On/Off T - This function allows you to keep the display permanent on or turn it off two
minutes after last pressing any button on the control panel.
Contrast - Use this function to adjust contrast of the display (0-100%).
Backlight - Use this function to adjust backlight of the display (0-100%).
Audio - Audio mode . If this mode is on, the effects on the Virtual Colour Wheel are controlled via sound and
do not respond to the speed control on the channel Special Functions.
Mic Sens - Microfon sensitivity . Enter the menu if you want to adjust the microphone sensitivity ( 1-max.,
19-min.).
Fans - Fan mode . Use the menu to set the fixture fan to the max. fan power mode (" High "), to the auto- control
mode (" Auto ") or to the silent mode (" Silen ").
Temp Uni - Temperature unit . Use the menu item to change temperature unit from °C to °F.
I Ef Pos - Init effect positions . Use the menu to set all effects to the desired positions at which they will stay
after switching the fixture on without DMX signal connected.
Defaults - The menu item allows to set all fixture parameters to the default (factory) values.
6.4 Manual Control (Manual)
Pres Eff - Preset effects . Use the menu to show preset positions of each channel effect.
Manual C - Manual control . Use the menu to control all fixture channels by means of the control panel.
6.5 Test program (Test Prg)
Use this menu to to run a special demo-test sequences without an external controller, which will show you some
possibilities of using the ParFect 100.
6.6 Stand-alone (St Alone)
The ParFect 100 offers three built-in programs (Prog 4-Prog 6 and "All") and three user-editable programs