Robe Robin Actor 3 Smart White, Руководство пользователя

Страница: 20 / 26

0
SENSOR_DEFINITION *
SENSOR_VALUE *
DISPLAY_INVERT
* *
DISPLAY_LEVEL * *
DEVICE_RESET
*
DMX_PERSONALITY * *
DMX_PERSONALITY_DESCRIPTION
*
STATUS_MESSAGES *
STATUS_ID_DESCRIPTION
*
DEVICE_HOURS *
PARAMETER_DESCRIPTION *
8. Wireless DMX operation
The wireless version of the Actor 3 is equipped with the Lumen Radio CRMX module and antenna for receiving
DMX signal. CRMX module operates on the 2.4 GHz band.
The item " Wireless " from the menu "DMX Input" allows you to activate receiving of wireless DMX (Pers-
-> DMX In -->Wireless.). The options from the "DMX Input" menu are stated in DMX chart as well (channel
Power/Special functions , range of 10-19 DMX). If DMX input option is changed by DMX command, the change
is permanently written into fixture´s memory.
DMX range of 10-19 switching fixture to the wired/wireless operation is active only during first 10 sec -
onds after switching the fixture on.
After switching the fixture on, the fixture checks both modes of receiving DMX in the following order:
1. For the first five seconds, the fixture receives DMX signal from the wired input. If the Power/Special functions
channel is set at some DMX input option, the fixture will receive DMX value according to this option. If DMX input
option is set to the wired input , this option is saved and checking procedure is finished. If DMX input option is
not set, the fixture continues next 5 seconds in scanning wireless DMX signal-see point 2.
2. For the next 5 seconds the fixture receives wireless DMX signal and again detects if the Power/Special
functions channel is set at some DMX input option, if not, the fixture will take option which is set in the fixture
menu "DMX Input".
To link the fixture with DMX transmitter.
The fixture can be only linked with the transmitter by running the link procedure at DMX transmitter .
After linking , the level of DMX signal ( 0-100 %) is displayed in the menu item “Wireless “ (Special -->Wireless
-->Stat).
To unlink the fixture from DMX transmitter.
The fixture can be unlinked from receiver via the menu item “ Unlink “ (Special --> Wireless --> Unlink).
9. Error and information messages
L. Z. 1 Short Err.
The message informs you that short circuit has occured on the PCB of LED zone 1.
L. Z. 2 Short Err
The message informs you that short circuit has occured on the PCB of LED zone 2.
L. Z. 3 Short Err
The message informs you that short circuit has occured on the PCB of LED zone 3.