Robe ColorWash 250 AT, Руководство пользователя

Страница: 25 / 32

5
P.t.SP. a pan/tilt speed
Colo. a colour wheel
CYAN cyan lamellas
MAGE.
magenta lemellas
YELL.
yellow lamelas
C.SPd.
a CMY/dimmer speed
Macr.
a CMY macro
EFFE.
an effect wheel
Zoom
a zoom
Stro.
a shutter,strobe
dimr a dimmer
S.tim. a step time,value 0,-5,5 seconds
COPY. - copying the current prog. step to the next prog. step .If the last prog.step is copied to the
next prog. step ,parameter "P.End" is increased about one automatically (except step 99).
5. Press [ENTER]-button to confirm adjusted value .
6. Press [MODE]-button,select next prog. step and repeat this procedure (steps 4 - 6).
9.9 Reset function
This option enables the ColorWash 250 AT to index all effects (functions) and return to their standard posi -
tions.
9.10 Special functions
Use this menu for special services like adjusting lamp or adjusting effects.
LA.Ad. --- Lamp adjustment .This function can be used when you make the fine adjustment of the lamp.If you
select this function,all effects will be canceled,shutter will be opened and the dimmer intensity will be set onto
00%.By using the options "
PAn, tilt
" you can aim the light on a flat surface (wall) and perform the fine lamp
adjustment.
CodE
---
Code
.This function contains identification hexadecimal code (0000-FFFF) for the fixture, which is
used for the master/slave operation.
rdML --- Code .This menu item shows the first part of an RDM identification code.
rdMH --- Code .This menu item shows the second part of an RDM identification code.
AdJ. --- Effect adjustment .By this function you can calibrate and adjust the effects to their standard/right
positions.Disconect the DMX controller from the fixture and select " AdJ. " menu.The display shows step by step
effects by which you can adjust the fixture to the required position before the function calibration(DMX controller
must be disconnected) . When the positioning is finished ,select "F.CAL." and press [ENTER]:
1. Calibration via the control board
Disconnect DMX controller from the fixture.Press [ENTER] and use [UP] and [DOWN] in order to display
the following items: "Colo,EFFE,Zoom,dimr" for very smooth function calibration. Select one of them, press
[ENTER] and use the [UP] and [DOWN] in order to adjust their right value from 0 to 55. Then press [ENTER]
to confirm or [MODE] to cancel and return to the menu. This can be repeated for each calibration parameter if
it is required. When the calibration is finished, it is necessary to use the
"A.rES"
function in order to write the
calibration values to the memory (EPROM) and to make a reset in order to check the newly adjusted positions
of the effects. When the reset of the fixture is finished, the display will show the
"F.CAL"
message. Press
[ENTER] to repeat the calibration or [MODE] to return to the
"AdJ."
menu.
2. Calibration via the external controller