6
4. Installation
4.1Fitting the lamp
DANGER !
Install the lamps with the device switched off only.
Unplug from mains before !
To insert the lamp , open the top cover of the projector head by loosening the 4 screws on the cover.
Then open the small lamp cover by loosening 3 fastening screws (see the drawing).
If changing the lamp, remove the old lamp from the socket. Insert the lamp to the socket.
Do not install a lamp with a higher wattage! A lamp like this generates temperatures the device is not designed
for.
Damages caused by non-observance are not subject to warranty. Please follow the lamp manufacturer‘s no-
tes!
Do not touch the glass bulb with bare hands during the installation! Make sure that the lamp is installed tightly
into the lampholder system.
Adjust the optimal distance -.5 mm from the lens by turning the screw
“A”
(see the drawings
“Lamp adjust-
ment” below) on the rear panel of the head.
Then close the small lamp cover by tighten 3 fastening screws again.
Reclose the top cover of the head and tighten the 4 fastening screws.
Before striking the lamp, reset the
“LAti/rSEt”
and
“LASt/rSEt”
counters in the “
InFO
” menu on the control
panel, by pressing the
“Up”
and
“Down”
buttons in one time and then confirming with the
“Enter”
-button.
Do not operate this fixture with opened housing-cover!
Top cover
Lamp
Fastening screws
Lamp cover
Fastening screws
