4
9.7 Stand-alone setting
Use this menu to set options for stand-alone mode as a selection of the playing program,programming and
modifying current programs.
Auto
---
Presetting playback
.This function allows you to select the program which will be played in the stand-
alone mode
after switching the fixture on.Selected program will be played continuously in a loop.
d.Abl
--- The option disables "Auto" function.
tESt
--- The option will start built-in test program.
PrG. 1
--- The option will start created program No.
PrG. 2
--- The option will start created program No.
PrG. 3
--- The option will start created program No. 3
Note:
If the fixture operates in the controller mode ( DMX controller is connected) and any program from this
menu is selected ,in this case the fixture will not respond to the DMX controller after switching on and will play
selected program.
PLAY
---
Playing program
.Select this menu to run a bilt-in program or the 3 freely-programmable programs
in a loop.
tESt
--- The option starts built-in test program.
PrG.1
--- The option starts created program No.
PrG.2
--- The option starts created program No.
PrG. 2
--- The option starts created program No. 3
Select the program you wish and press [ENTER].The selected program starts running.By Pressing [ENTER]
again is possible to pause the program running.
Edit
---
Editing program
.Select this menu to edit or create the program.The ClubSpot 300 has one built-
in program and the 3 free programs,each up to 99 steps.Each program step has a step time.Step time-the
time,during which effects last in the current step.
If the fixture is set as a master ,then you may edit any program in the slaves.You can't edit programs on the
slave fixtures from their control panels if the master fixture is switched on and connected to the slaves (editing
is possible by the master control panel only).
Procedure:
1. Press [UP] or [DOWN] to select the program you want to edit ("PrG.1" - "PrG.3") and press [ENTER].
2. Press [UP] or [DOWN] to select the desired fixture ("MASt." - "SLA.9") and press [ENTER]-button.
3. Press [UP] or [DOWN] to select the desired program step ("St.01" - "St.99") and press [ENTER]-button.
4 Press [UP] or [DOWN] to select the desired item and press [ENTER]-button.Now you can edit by [UP] o r
[DOWN] buttons the DMX value (0-255) for selected item:
P.End. -
a total number of the program steps (value 1-99).
This value you must set before start
programming
(e.g. if you want to create program with the 10 steps,set P.End=10).
PAn
a coarse pan movement
EFFE.
a prism
tilt
a coarse tilt movement
Prot.
a prism rotation
SpEd
a pan/tilt speed t
r.Gob.
a rotating gobo wheel
Func.
a special function
G.rot.
a gobo rotation
Colo
a colour wheel
Foc.
a dimmer
Stro.
a shutter,strobe
dimr
a dimmer
S.tim.
a step time,value 0,-5,5 seconds
COPY.
- copying the current prog. step to the next prog. step .If the last prog.step is copied to the
next prog. step ,parameter
"P.End"
is increased about one by itself (except step 99).
5. Press [ENTER]-button to confirm adjusted value .
6. Press [MODE]-button,select next prog. step and repeat this procedure (steps 4 - 6).
9.8 Reset functions
This option enables the ClubSpot 300 to index all effects (functions) and return to their standard positions.
