0
4.6 Replacing graphic wheels
Install graphic wheels with the device switched off only.
Unplug from mains before!
The dual graphic wheel consists of two graphic wheels.
To replace graphic wheels.
1. Disconnect the fixture from mains and allow it to cool.
. Remove the plastic cover of the head by loosening the 4 quarter-turn fasteners on the cover.
3. Unscrew both screws (1) to remove the sensor holder.
4. Tilt up the dual graphic wheel to the position when graphic wheels are accessible.
5. Remove the spring lock (2) with an appropriate tool (e.g. small-bladed screwdriver) and remove it.
6. Remove the graphic wheel (3) and insert the new one (glazy side towards the lamp, black side towards
the objective!). Insert the spring lock to secure it in the graphic wheel holder.
7. Use the same steps (4-6) to change the second graphic wheel
.
8
. Screw the sensor holder back to the fixture chassis.
9. Put the bottom cover back before applying power.
4.7 Installing handle for the Follow Spot Mode
Before installation of handle (handles) , switch the fixture to the Follow Spot Mode (Personality--> Follow Spot
Mode). You can install one or two handles in different positions as needed. See picture below. Before switching
the Follow Spot Mode off, remove handle (handles) from the fixture.
Содержание BMFL Robin Spot Woreless DMX CRMX
