ROBBE POWER PEAK MAXAMP 8121, Руководство по эксплуатации

Страница: 13 / 58

Display battery voltage at TX / RX output
The letter „C“ means CHARGING, and may be replaced by R = READY, D = DISCHAR-
GING, D/C = DISC-CHAR (active state flashes), C/D - CHAR-DISC (active state flashes)
or N = NO BATTERY.
All displayed parameters are erased when you connect a new battery, or switch from
discharge to charge or vice versa, and the capacity values are shifted back by one place
(from M1 to M2, etc.).
Modes of operation
The following modes of operation can be selected using the MODE button, and activated
by pressing the START / STOP button.
Single CHARGE process
Single DISCHARGE process
Multiple CHARGE-BEFORE-DISCHARGE process, number
of cycles variable using CURSOR buttons
Multiple DISCHARGE-BEFORE-CHARGE process, number
of cycles variable using CURSOR buttons
Additional screen displays
No battery connected
Ready for use
Battery connected with reverse polarity / short-circuit at output
Additional information
- The termination criterion (Delta Peak method or temperature monitoring) is selected
indirectly by the settings you make relating to termination temperature and Delta Peak
sensitivity. If you select the Delta Peak method of charge termination, the termination
temperature must be set to the maximum value of 60ºC. If you wish the unit to termina-
te the charge process using temperature monitoring, Delta Peak sensitivity must be set
to the maximum value of 20 mV/cell, and the termination temperature set to the desired
Operating instructions
POWER PEAK MAXAMP
Order No.
8121
14
NO BATTERY
READY
TX&RX 10.90V C
CHARGING
DISCHARGING
CHAR - DISC 01 TIME
DISC - CHAR 03 TIME
SHORT / REVERSE