ROBBE 2659, Инструкция и руководство пользователя

Страница: 15 / 24

ENGLISH
15
INSTRUCTIONS AND USER MANUAL
M o d e l l s p o r t
PREFACE
Congratulations on your purchase of the new AVALANCHE.
The AVALANCHE is a high-quality and durable allround motorglider with sportive flying characte -
ristics. It can be flown within in a broad speed range. There are various ways of constructing the
model, depending on your preferences and own experiences. Therefore the solutions stated in this
manual should only be considered as recommendations. The ARF version (almost ready to fly) re -
quires modeling experience and basic technical knowledge in construction. Thus there are different
ways to achieve a model with good flight skills. This is why most alternatives are in fact explained in
the manual but not necessary shown in the pictures.
Please read this manual carefully before you start assembling the model.
TECHNICAL DATA
BOX CONTENT / NEEDED ACCESSORIES
Span 2800 mm
Length 1490 mm
Weight (dry) 1580 g
Flying weight 2690 g
Wing Area 53,4 dm²
Airfoil Spezial
C.G.
76-85 behind
the leading edge
Elevator Yes
Rudder Yes
Ailerons Yes
Flaps Yes
Landing flaps No
Motor Yes
FLIGHT INSTRUCTIONS
• Before the first flight, observe the instructions in the „Safety Instructions“ section.
• When flying the model, you should choose a day with as little wind as possible
• A large, flat area without obstacles (trees, fences power lines etc.) is suitable for the first flights.
• Please carry out a functional test of the drive train / power set and remote control.
• After assembling the model on the airfield, check once again that all model components such as
wing, tail units, wing mounts, engine, linkages, etc. are firmly and properly fastened.
• For a hand start a helper should be present, who can throw the model with enough thrust into the
air.
• The start usually takes place against the wind.
• Do not stall the model near the ground
• Do not initiate tight turns in the immediate vicinity of the ground.
• Check the reactions of the model to the rudder deflections. If necessary, adjust after landing to
increase or decrease the deflections accordingly.
• The minimum flight speed must be at an adequate safety altitude.
• Initiate the landing with sufficient speed
SAFETY INSTRUCTIONS FOR RECHARGEABLE BATTERIES
• Do not immerse the battery in water or other liquids.
• Do not heat, throw into fire or microwave.
• Do not short-circuit or charge with reversed polarity
• Do not expose, deform or throw the battery
• Do not solder directly on the battery
• Do not change or open the battery
• Only charge the battery with suitable chargers, never connect it directly to a power supply unit.
• Never charge or discharge the battery or charger on a flammable surface.
• Never leave the battery unattended during charging or discharging processes.
• Never charge or discharge the battery in direct sunlight or near heaters or fire.
• Do not use the battery in places subject to high static discharge.
All this can cause the battery to be damaged, explode or even catch fire!
• Keep the battery away from children
• Keep leaked electrolyte away from fire, as it is highly flammable and may ignite.
• The electrolyte liquid should not get into the eyes, if it does, rinse immediately with plenty of clear
water and then see a doctor.
• The electrolyte liquid can also escape from clothes and other objects with a lot of water or was -
hed off.
• Observe the safety instructions of the battery manufacturer and the charger manufacturer.
Item number ARF
Motor 5800 Ro-Power Torque X-36 800kv (not included)
ESC 8710 Ro-Control 80A (not included)
Battery 7342 Ro-Power Ultra HP 4S 3200mAh (not included)
Servo ELE 9111 1xFS-155 BB MG HV (not included)
Servo RUD 9111 1xFS-155 BB MG HV (not included)
Servo AILE 9114 2xFS-128 BB MG HV (not included)
Servo FLAP 9114 2xFS-128 BB MG HV (not included)
Servo LANDING FLAP no no
Servo cable - 6x25cm, 2x75cm, w. loose cable (solder) (not included)
Transparent tape - yes (not included)
MULITlock 725142 yes, optional (not included)
MPX plugs 40010, 40011 2 pair (not included)
Adhesives 45900 UHU Por (not included)
Epoxy resin 50604 10-Min Epoxy resin (not included)
Locking screw 5073 yes (not included)
Velcro strap 59001009 yes (not included)
Spinner 20736 Alu Turbo Spinner 38/5mm (not included)
Propeller 7234/57 13x8“ (not included)
TX - min. 5 channels (not included)
RX - min. 7 channels (not included)