4
Roband or one of our service agents.
Cleaning the control panel:
Do not use a detergent or an alkaline spray to
clean the control panel as this may cause damage.
Use a dry or a cloth lightly dampened with water
to clean.
Cleaning the Microwave interior:
After use, clean up any spilled liquids, spattered
oil and food as quickly as possible. If the oven is
used while dirty the efficiency drops and the food
may get stuck on the interior. Clean the interior
with a cloth soaked in warm water with mild
detergent dissolved in it, and then rinse any
residue off with a damp cloth.
Regular cleaning will prevent a build-up of oils
and foodstuff and keep the machine looking new.
INSTALLATION
IMPORTANT: DO NOT USE THE MICROWAVE
DOOR HANDLE TO LIFT THE MICROWAVE
OVEN.
Any damage to the machine as a result of freight
must be reported to the Freight Company and to
the agent responsible for the dispatch of machine
within 24 hours of receipt. No claims will be
accepted after this period.
Do not under any circumstances attempt to use
a damaged product.
Remove all packaging materials, tape, and any
protective plastic from the machine. Remove any
glue residue from the protective plastic or tape
using citrus cleaner.
Product should be installed at counter height only
(approximately 800- 1100mm). Installing outside
the recommended mounting height could cause
damage to the door hinges and prevent
operation.
Do not position the microwave on top of or
immediately above another appliance.
Place the product on a firm, level surface in the
desired position.
Allow at least 150mm clearance from top, back
and sides when positioning the microwave.
Do not obstruct filter or ventilation openings.
Install away from TV and radio sets as reception
and radio interference might be affected.
Do not position Microwave near sources of heat,
water, oil or steam.
Do not stack any appliances or materials on the
top of the microwave.
Do not connect to power using an power board
or extension cord.
WARNING:
This product must be connected to
an RCD protected circuit, ensure the circuit is
properly earthed.
Before connecting the machine to the power
supply, ensure that all switches are in the OFF
position.
