14
OM2750.docx
Roaring Forties Accessories
Re-arm kit (KIT160-60)
For SMA 2751
Re-arm kit (KIT400-60). For SMA 2752
Re-arm kit (KIT029-60) For SMA2752 with sealing cap
Cleaning and Storing of Your Inflatable PFD SMA2751
Remove the CO2 cylinder. Use warm, soapy water to hand wash your PFD with a sponge and rinse it off with
clean water. Dry your PFD using a plastic coat hanger. After drying, remember to re-reinstalled the CO2 cylinder
to the inflator. See
Re-arming your PFD After Manual Inflation (SMA2751)
.
Your Inflatable PFD should be stored in a warm, well ventilated & dry place & out of direct sunlight.
Cleaning and Storing of Your Inflatable PFD SMA2752
Remove the CO2 cylinder and auto cartridge. Keep the cartridge dry. Use warm, soapy water to hand you’re your
PFD with a sponge. Rinse your PFD with clean water. Dry Inflatable PFD using a plastic coat hanger. Ensure the
inflator is thoroughly dry before installing the automatic cartridge. Make sure to re-install an unused CO2 cylinder,
(see
Re-arming your PFD SMA2752 as Manual with Automatic Backup or Manual only
).
Your Inflatable PFD should be stored in a warm, well ventilated & dry place and out of direct sunlight.
.
WARNINGS:
Do not repair or alter the design of your PFD;
Do not double inflate your PFD – an action where an oral inflation is followed up with
a COs gas cylinder inflation. This may over pressurise your PFD. Thus causing
unnecessary damage to your PFD & even personal injury;
Do not use other size CO2 cylinder except 60gm CO2 gas cylinder;
Do not flex, twist or wring your PFD unnecessary;
Do not store your PFD in confined areas for an automatic. Inadvertent inflation
may cause damage;
Do not place your PFD in front of heater or direct sunlight. Your PFD welded seams
may delaminate rendering your PFD as unusable.
Do not forget to routinely check the integrity of you PFD
