10
OM2750.docx
RE-ARMING ACCORDING TO YOUR MODEL
The following are the Roaring Forties re-arming kits:-
For SMA 2751, the kit to use is KIT160-60.
For SMA 2752, the kit to use is KIT400-60.
For models requiring sealing cap, the Kit is KIT029-60
All these are available at Safety Marine Australia
Re-arming Your PFD after Manual Inflation -SMA2751
- Unscrew the used CO2 cylinder & install an unused 60gm CO2 cylinder back to the inflator using a
Roaring Forties re- arming kit (KIT160-60).
- Do not over-tighten as this may damage the gasket
- Replace the green indicator and adjust the manual lever to an upright and ready position (Fig. 1)
- Repack your PFD in accordance with instructions given in subsequent section (pages 11 & 12).
YOUR PFD IS NOW READY FOR USE.
Re-arming your after inflation PFD as Manual / Automatic Backup SMA2752
- Unscrew the used CO2 cylinder and discard it
- Unscrew and remove the auto cartridge (Fig. 6).
- Using Roaring Forties kit (KIT400-60), install a new auto cartridge with the green indicator at base and
gently hand tighten to the inflator.
- Check to see the manual lever is in the upright and ready position with the green indicator clip properly
installed. If the green indicator clip is missing or damaged, replace it (Fig. 6).
- Install an unused CO2 cylinder by screwing it into the top of the inflator and hand- tighten. Do not over-
tighten as this can damage the internal gasket.
- Refold the PFD in accordance with the Repacking instructions (p. 11).
YOUR PFD IS NOW READY FOR MANUAL USE WITH AUTOMATIC BACKUP
Note on the Automatic PFD:
With all automatic PFDs, your PFD is also prone to premature inflation without your knowledge especially when it
is exposed to a moist, wet or humid environment. Unless you inspect it frequently, your PFD may not be armed
when needed.
Do not store your automatic in a very tight & confined area as inflation may damage your PFD.
Repacking
