Roadtrek SS-Ideal, Руководство пользователя

Страница: 15 / 72

DAILY LIVING
Doc No: 21906550 Rev: 00 Copyright © Roadtrek Motorhomes Inc. 2009 B-2
SLIDE OUT OPERATION:
4• Bring each of the rear doors back to the side of
the slide and fasten with the Nylon strap and clips
provided, then pull the loose end of the strap to
tighten underneath the slide (See Picture B-P6).
RETRACTING THE SLIDE OUT ROOM:
1• Disconnect the Nylon strap on rear doors and
open doors fully to the magnetic stops.
2• Remove and store the dinette table if set up.
3• Remove cushions from side seats (if used) and
flip the seat bases up, ensuring that the white turn
buttons are engaged to hold them in position. (See
Picture B-P8. Failure to do this could cause damage
to these seats when the slide comes in.
4• Ensure that the area between the slide out,
fridge and galley is fully clear of any persons or
materials and that there are no persons sitting in
the slide out.
5• Press and hold the forward side of the slide out
switch until the room stops and then release it. DO
NOT continue to hold the switch after it stops. If the
room stops only part way in, release the switch
immediately, check for any obstructions, and wait
30 seconds before trying again.
6• Once the room is fully in, check for
obstructions, close and lock the storage
compartment, close the rear doors, and resecure
the tire carrier (if applicable).
Picture B-P6: Rear doors showing storage area and
restraint strap (hanging loose).
Picture B-P8: Driver side rear side seat base folded
up showing turn button location.
Picture B-P7: Rear door strap can be kept in the
mesh pocket on the rear door for storage. (good
idea to keep a flashlight here as well)
Turn
Button
Clip for strap
(one on each door)