Roadtrek 190 Chevrolet, Руководство пользователя

Страница: 61 / 93

CITY WATER CONNECTION:
NOTE: City water connection can only be used in summer operation mode.
The city water inlet connection is located in the small compartment behind the large lockable driver side
storage compartment, see Picture G-P2. To connect the water system to an outside source:
1. Ensure that the water pump is turned off.
2. Close the city water tank fill shut off valve by turning the handle to the vertical position, see Picture
G-P4.
3. Be sure that all interior water outlets are closed to prevent spillage.
4. Open the city water source slowly to prevent excessive water force inside your vehicle. (To protect
your system from excessive pressure from water supply systems encountered in some areas, a
water pressure regulator should be used. Such a regulator is not supplied with your vehicle).
5. Note that this connection by-passes the water pump and fresh water tank. Therefore, the use of
these items is not necessary when connected directly to an external water source.
To disconnect the city water connection:
1. Turn off the external water source.
2. Open the sink faucet to relieve the pressure in the system (failure to do so may result in an
unexpected shower).
3. Ensure that the city water tank fill shut off valve is closed, see Picture G-P4.
4. Remove the hose from the city water connection, replace the cap on fill connection.
WATER SYSTEMS
Page G.3
Printed in Canada
Copyright     Hanmar Motor Corporation 2001
Doc No: FMSA0002 Rev: 01