Roadtrek 190 Chevrolet, Руководство пользователя

Страница: 52 / 93

REFUELING PROCEDURES:
WARNING: Do not refuel the L.P.G. tank to more than 80% of its capacity.
A properly refueled L.P.G. tank will hold approximately 80% of its volume in a liquid state. Over fueling of
the L.P.G. tank can result in uncontrolled gas flow which can cause fire or explosion.
WARNING
: The tank valve must be closed and ALL PILOT LIGHTS,
APPLIANCES, AND THEIR IGNITERS (see Operating Instructions)
SHALL BE TURNED OFF during refueling of motor fuel tank and / or
the L.P.G. tank. Only qualified personnel should refuel your L.P.G.
tank.
REGULATOR:
The L.P.G. regulator is located adjacent to the L.P.G. tank.
This regulator has been installed in a protective cover to keep out debris, and with the vent facing
downward. Ensure that the regulator vent always faces downward to minimize vent blockage which could
result in excessive gas pressure causing fire or explosion.
L.P.G. LEAK DETECTOR:
Your vehicle has been equipped with a L.P.G. leak detection device for your protection, see Picture F-P1.
See “Floor Plan & Appliance Location” for location of the L.P.G. leak detector location.
Picture F-P1:
L.P.G. leak detector.
Be sure the detector is operating while using your vehicle. Do not block air circulation in the area
where the L.P.G. leak detector is located.
See Manufacturer's Owner's Manual for other operating instructions.
*WARNING: Battery disconnect switch must be in the “ON” position for detector operation.
L.P.G. (Liquid Propane Gas) AND SAFETY SYSTEM
Page F.2
Printed in Canada Copyright     Hanmar Motor Corporation 2001 Doc No: FMSA0002 Rev: 01