Roadtrek 190 Chevrolet, Руководство пользователя

Страница: 16 / 93

SLEEPING FACILITIES:
REAR TWIN BEDS (Popular):
To convert the dinette into twin beds:
1. Remove the table and leg from its receptacle and place the table under the driver side seat
cushion.
2. Place both back rest cushions on the floor vertically up against the seat base boxes or store if
desired.
3. Pull each seat cushion 3” (8 cm) from the wall to provide additional elbow room while sleeping.
4. Night table can be removed (see below) and stored if desired.
To convert back to a dinette, perform these steps in reverse order.
REAR KING-SIZE BED (Popular):
To convert the dinette into a king-size bed:
1. Remove the privacy curtain from its Velcro support on the lower edge of the suspended cupboard
door.
2. Remove the table and leg from its receptacle.
3. Remove night table and store. In order to remove, one must open the rear door and unscrew the
wing nut found in the rear storage area, see Picture B-P9. Store wing nut in the night tables drawer
when not in use.
Picture B-P9:
Wing nut attaching the night table, needs to be
accessed from the rear storage area (Popular).
4. Place table top in center and wood piece as shown in
Picture B-P10.
Picture B-P10:
Placement of support pieces
for the king size bed (Popular).
5. Place both bolster cushions (back rests) in centre in a
teepee position, as shown in Picture B-P11. NOTE: The longer bolster cushion must be placed on
the driver side, so as to provide clearance for the bathroom door.
6. Push down the bolster cushions so they lay flat to create the king size bed.
DAILY LIVING
Page B.4
Printed in Canada
Copyright     Hanmar Motor Corporation 2001
Doc No: FMSA0002 Rev: 01