RMS Gill 2, Инструкция по установке и эксплуатации

Страница: 9 / 20

9
6. Move the Gill 2 rearwards until the Seat
to Backrest Hinges are level with the
backend of the Seat Rails. Fig.3.
7. Slide the rear Seat Positioning Clamps
forwards to contact the front Seat Hook
Brackets and lightly tighten clamping
nuts, just sufficient to maintain the
Clamp positions at this stage.
8. Slide the front Seat Positioning Clamps
rearwards to contact the front Seat
Hook Brackets and lightly tighten
clamping
nuts, just sufficient to
maintain the Clamp positions at this stage.
NOTE: It is important to ensure correct positioning and security of the
Clamps as their purpose is to correctly locate and prevent movement of the
Seat Base when in service.
Please also refer to the sections on Seat Unit Adjustments pages 11 to 16.
9. To ensure correct positioning of the Clamps and ease of removal and refitting of
the Gill 2, the Seat Unit should be removed from the wheelchair, by lifting both
sides of the Seat Unit which will enable the wheelchair to partially fold,
sufficient to lift the Seat Unit clear of the wheelchair.
At this stage, make any minor adjustments to the Clamp positions before fully
securing the Clamps sufficient to prevent any movement.
CAUTION: Ensure the Clamp securing
nuts do not foul the Parking Brake
Mounts or front Seat Rail Saddles when
tightening, adjust the Clamp or Hook
Bracket positions accordingly if
necessary before fully securing.
10. Re-install the Gill 2 onto the wheelchair
as described in sections 4, 5 and
6
.
11. With the Seat Unit now in place on the
Seat Rails, route the Backrest Retaining
Straps outwards in front of the Backrest
Tubes, then around the outside of the
Tubes, finally to be connected centrally
by the Main Buckles as Fig.4.
12. With Buckles connected, the Straps can
be tensioned by pulling the free-end
“D” Ring Straps outwards to remove any
slack.Fig.4
NOTE: Ensure Backrest Alignment
Brackets Fig.4 are correctly located
between the Backrest Tubes before fully
tightening Straps.
For Gill 2 Seat units supplied as a package with an Action model
wheelchair, see instructions on page 10.
Fig.3
Pull-tight
Straps with
“D” Rings
Backrest
Alignment
Brackets
Fig.4
Backrest
Retaining Strap
Main Buckles