Connect power
The Smart Relay Output has redundant power terminals to accommodate a backup power supply in the event
of an outage. Follow these steps when attaching wires to power terminals located on the bottom of the module.
• Check that DC power source voltage matches the accepted voltage range of the device.
• Remove power from the DC power source prior to connecting to the Smart Relay Output.
• Connect the DC power cables to the terminal pairs. The power terminals are not polarity sensitive.
• Energize the power source. The PWR LED will be ON indicating that the system has power.
System alarm wiring
Connect alarm relay monitoring equipment wire pair to the alarm contact on the bottom of the device.
• Use the NO or NC contact positions as required.
• The alarm terminal block may be removed and accepts wire sizes 16~26 AWG.
• Fully seat the terminal block back into the connector before operating the system.
Start the system
Once a local power source is connected and turned on the PWR LED will turn ON. The STS LED will be
blinking to let you know the device is operating normally..
Installation
11
