4.
Quick Start Guide
Easy Installation
Before starting
•
Review the safety information in section
1. Important Information
•
Familiarize yourself with the fiber switch as described in section
2. Introduction
•
Know how to handle fiber optic cable, have a suitable installation environment with the correct power, as described
in section
3. Before Installing
Install the Switch
The switch is pre-configured at the factory for general application, and will operate without any setup. For
additional configuration instructions please refer to
5. Configuring the System
.
•
Mount the switch in a 19” equipment rack, on a shelf or table
Connect power
Remove power from AC mains supply. Connect the AC power cord to the terminals on the switch and plug
into 110/240VAC, 50/60Hz mains outlet.
•
Alternately, wire AC mains power directly from AC power source to the power terminals.
Connect fiber cables
•
The fiber cable(s) must be the correct type of cable, with the correct connectors and suitable length.
•
Attach the connector(s) carefully using care to avoid bending the fiber cable too sharply and damaging the fiber.
•
Do not touch fiber connector ends which could cause contamination and lower signal performance.
Caution
Radiation emitted by laser devices is dangerous to human eyes. Avoid eye exposure to direct or indirect
radiation.
Do not operate without fiber cable attached or dust caps installed.
Connect ethernet cables
•
Attach ethernet cables to the RJ-45 ethernet ports labeled 1 through 16 on the rear panel of the switch.Start the
system
Quick Start Guide
15
