IMR01M01-E5
10
6.2 Display Sequence
6.2.1 Selecting parameter group
After power-on to the instrument, the display automatically goes to Input Signal Monitor 1 in Parameter Group 1. To go to
Parameter Group 2 display, press and hold the Parameter Key for 2 seconds.
Parameter group 1
Press the parameter
key for 2 sec.
Parameter group 2
Press the parameter
key for 2 sec.
6.2.2 Changing parameter settings
Parameter key: Used for parameter calling up and set value registration.
UP keys:
Used to change the numeric value.
Example: Change control method (parameter group 1) from phase control to zero-cross control
Parameter group 1
Input signal monitor 1
Press the parameter key
twice to display the control
method.
Control method
Control method
Press the UP key under
the first digit from the right
to change the value to 1.
Control method
Press the Parameter key to
go to the next parameter.
Soft-start time
Control method
Setting range (Control method)
0: Phase control
1: Zero-cross control
When the value is changed, it will
be automatically stored after three
seconds without any key operation.
The value will be also stored if the
Paramter key is pressed.
Other parameters can be set in the same way as the example above.
6.2.3 Parameter list
Parameter group 1
Name
Parameter
Symbol
Display range
or
Setting range
Factory
set
value
Details
Reference
page
Input signal
monitor 1
No
parameter
0 to 100 %
Displays one of the following values
depending on the control mode and
the setting of Contact Input Action.
•
Input signal from controller
•
External Manual Set value
•
Internal Manual Set value
For this selection, see item 7.1 Selecting
Manual Mode Type and Input Signal
Monitor 1 (P.14).
P. 14
Phase angle ratio
monitor
0 to 100 %
When 0 %:
phase angle 0
°
When 100 %:
phase angle180
°
Control method
0: Phase control
1: Zero-cross control
0
Select the control method.
P. 14
Continued on the next page.
25 %
50 %
75 %
100 %
Phase angle
180
°
Phase angle
135
°
Phase angle
90
°
Phase angle
45
°
Display this value.
