8
Setup Mode
To configure the Y-Not, you must first enter setup mode. Holding
down selected buttons while powering the unit on will bring up
selected setup modes, as detailed in this section.
Selecting MIDI Channel
Hold the A button while powering the Y-Not on. Keep holding the
button until the LEDs flash. The Switch buttons will now allow you to
select the MIDI channel the Y-Not responds to.
The Y-Not is set by default to send and receive on MIDI Channel 1. To
change the send/receive channel:
MIDI
Channel
A LED
B LED
1
OFF
OFF
2
ON
OFF
3
OFF
ON
4
ON
ON
Saving MIDI Channel
Once you’ve set the MIDI channel and options, press the Write
button. The Y-Not is now in normal operational mode.
Selecting Other Options
There are two other options that can be set on the Y-Not. To access
and change these options, hold the B button while powering on the
Y-Not. Keep holding the button until the LEDs flash.
Once you’ve entered this mode, you can adjust the following
settings:
