7
Installation guide
Assembling the headboard bracket (optional)
Note: headboard bracket kit is sold separately (order as SKU 2310014).
Parts included in headboard bracket kit:
• Inner headboard brackets (small) (2)
• Outer headboard brackets (large) (2)
• Small screws (for inner headboard bracket) (2)
• Large screws (for outer headboard bracket) (2)
• Small washers (for inner headboard bracket) (2)
• Large washers (for outer headboard bracket) (2)
Hardware to attach headboard to brackets is not included.
If the bed is in use, remove all bedding and the retainer bar. With two people, flip
the adjustable bed over so that the top side faces the floor.
Remove both of the legs from the head section of the bed by turning them in a
counterclockwise direction.
Slide the short, inner headboard bracket over the round panel where the leg was.
Make sure the bracket opening is on the outside of the bed. Then, re-attach the
leg to the bed by putting the screw in the leg through the bracket and into the
hole in the round panel. Turn the leg clockwise to secure.
Place the open side of the large, outer headboard bracket over the inner head-
board bracket end piece. The long slots on the outer headboard bracket should
line up with the screw hole of the inner headboard bracket. The vertical part of the
outer bracket should be on the outside of the bed, as shown.
Secure the outer headboard bracket to the inner headboard bracket using a
large screw and washer. The width of the outer headboard bracket should align
to the width of your headboard. Repeat on the other side. Once both brackets
are aligned properly, tighten the screw with an Allen wrench (included with the
headboard bracket kit).
Attach the legs of your headboard to the vertical sections of the outer head-
board brackets using the headboard attachment hardware. Any necessary
hardware should be included with your headboard and is not included with the
headboard bracket kit.
T
he headboard brackets can be adjusted for optimal distance between the headboard
and your adjustable bed. We recommend leaving a distance of 1.5” to 2” between the
bed base and the headboard bracket.
1
2
3
4
5
6
NOTE: The slots of the vertical end of the outer headboard brackets shoud align with the slots on the leg of your
headboard. if the slots are not aligning, adjust the width by unscrewing the outer headboard bracket to realign
with your headboard's slots.
7
