6
Owner’s manual |
Clarity II-E
adjustable bed
Installation guide
NOTE: For safety reasons, any lifting of the adjustable bed must always be performed by two (2) people. The
unit should be on a flat surface before opening.
Setting up your adjustable bed
With two people, carefully lift the bed base out of the shipping carton and place it
flat on the floor with the top side facing downward. Verify that all parts are avail-
able before discarding any packing materials.
Unfold the base.
Keep the top side facing down.
For all sizes.
1
2
Plug the input power cord into the power supply.
Connect the power supply to the control box, which is the black box attached to
the bottom of the bed.
Assemble the legs using any combination of the 3", 4", and 8" leg sections to choose
your bed's desired height. All legs must be the same height.
Attach the legs to the threaded holes in each corner of the frame. Tighten until
secure, but do not over-tighten.
Next, the remote control will need to be paired to the bed. Put the included AAA
batteries into the battery compartment on the remote control.
Find the pairing button on the control box on the underside of the bed. Plug the
power cord into the wall outlet, and then press and hold the pairing button for three
seconds. A light will flash to indicate the bed is ready for pairing. Press any button
on the remote control (except the flashlight button). A beep will sound that indi-
cates the remote has been paired with the base.
Unplug the bed from the power outlet. With two people, turn the bed over so that
the legs are on the floor. Do not rest the bed on the legs while flipping it over, as
that can cause damage.
Make sure the cords do not interfere with operation of the bed. Plug the power
cord into a grounded electrical outlet. A surge protector (not included) is recom-
mended. Verify that the bed is operational by using each function on the remote.
Then return the bed to a flat position.
Insert the mattress retainer bar into the two holes at the foot end of the bed. Place
your mattress and bedding on top. Your adjustable bed is now ready to use.
3
4
5
6
7
8
9
6
Owner’s manual |
Clarity III
adjustable bed
10
Input power cord and power supply
Connect power supply to control box
Attach legs to discs on the bed's frame
Use the pairing button on the control box
11
