WWW.RSIWW.COM
36 of 45
8.5c
Hold two profiles together in place at ridge using one
B-4 connector. Insert two T-bolt assemblies, line up
center hole with long hex bolt in roof ridge. Secure
T-bolt assemblies
as shown.Place
washer on long
bolt and secure
with S-2C cap.
F-1
F-1
R-1
B-4
From inside, hold profile in place with
one B-4 connector. Secure with two
T-bolt assemblies as shown.
8.5B
F-1
B-4
F-1
From inside, hold profile in place with one B-4 connector.
Secure with two T-bolt assemblies as shown.
8.5e
F-1
B-4
F-1
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
Hold two profiles
together at ridge
using one B-4
connector. Secure
with two T-bolt
assembies.
8.5f
R-1
F-1
F-1
B-4
8.5A
NOTE: VIEW FROM OUTSIDE.
NOTE: VIEW FROM OUTSIDE.
Remove next bungee cord and continue working from
back to install section four. Remove plastic film
from both sides of one W-1 panel. With side
marked “ UV Resistant” facing outside,
install the next panel on the left at the back.
Push panel into roof ridge channel until the
other end rests on gutter ledge and then
slide towards F-1 profile at back.
8.5D
Remove plastic film from both sides of one W-1
panel.With side marked “ UV Resistant” facing
outside, install the next panel on the right at the
back. Push panel into roof ridge channel until the
other end rests on gutter ledge and then slide
towards F-1 profile at back. Repeat to install
W-1 panel on left.
W-1
W-1
W-1
F-1
W-1
S-2C
S-7
B-4
S-5B
5
4
14
12
5
2
Profile
Panel
Connector
QTY
QTY
QTY
56”
24” x 57”
