Page 2 of 2
If it becomes necessary to remove a drawer, follow
these steps. With the drawer fully open, the drawer
slides must be released by pushing the "trigger" located
in the slide either up or down, depending on which
slide is being released. With both triggers pushed,
gently pull the drawer until the slides release.
Carefully reinstall the drawers by aligning the channels
of the drawer slides and gently pushing the drawers
back into the cabinet.
Step 3. Connect the End Frames (B) to the proper end of the Desk Top using the Allen Head Bolts (D),
Spring Washers (F), and Flat Washers (E). Only partially install bolts until the entire Desk has been
assembled.
Step 4. Install the Back Stretcher (C) between the two End Frames.
Step 5. Tighten Bolts previously installed using the 5mm Allen Wrench.
Step 6. Connect the ends of the Back Stretcher using the Allen Head Bolts (H), Spring Washers (F) and Flat
Washers (E). While pulling end of Stretcher snug to the End Frame, tighten bolts using the 4mm Allen
Wrench (G).
Carefully set the Desk
upright and reinstall
Drawers back into
the Desk if necessary.
pull out
Vogue
Home Office
Assembly Instructions
Made in Viet Nam
#46130-2
