SteelConnect SDI-5030 Gateway Hardware Installation Guide
37
Replacing network interface cards (NICs)
Replacing SteelConnect Gateway SDI-5030 Components
2.
If you are replacing an existing card, carefully pull the card from the riser. If you are not replacing a
card, remove the filler panel from the slot by pushing it from the inside of the gateway.
3.
Hold the new card between the front bezel and the rear of the card to avoid ESD damage.
4.
Plug the card into the riser slot and attach the bracket to the riser assembly near the rear panel.
The NICs fit horizontally into the PCIe enclosure.
Note:
Make sure the cards are seated properly in the enclosure. The cards are not functional if they are not seated
properly.
Figure 3-20. Installing the riser assembly
5.
Plug the assembly into the riser slot on the baseboard and fasten the screw.
Figure 3-21. Installing a PCI adapter to the riser assembly
6.
Replace the cover on the chassis.
7.
Connect the power cords.
8.
Connect the cables.
9.
Power up the gateway and check the status lights.
For information about the
status lights, see the
“SteelConnect SDI-5030 gateway LEDs” on page 8
.
