HD Series
RC6702HD-6311 Installation Guide
05-2014-A
www.rivatech.de
9
Caution
!
Caution
!
Sealing gaps is recommended as gaps may appear after the camera installation.
Gaps may cause problems such as moisture, water leakage and etc., which
negatively affects the operation of the camera if gaps remain unsealed.
To prevent products from damage, place the camera on a stable and non-
vibrating surface. If the stability is in doubt, consult safety personnel for
reinforcements, and then proceed with the installation.
1)
Place the installation template included
in the package on the desired installation
surface.
2)
Drill three holes in correct positions
based on the template paper, and insert the
anchor blocks into the holes.
3)
Attach the silicon waterproof band
included in the package to the camera’s
mounting surface by aligning it with the
three alignment holes.
4)
Connect the required cables including a
power cable and a LAN cable to the device.
Refer to the image on
5. CONNECTIONS
for
the right connections.
5)
Place the camera body to match the
three alignment holes with the three anchor
blocks, and hold the camera against the
surface where the camera will be mounted.
6)
Tighten the anchor blocks with the
screws.
7)
Adjust the heading direction of the
camera. Refer to
4.2. Adjusting angle of the
camera
for more details.
8)
Attach the lens cover on the main body
by rotating it clockwise.
*
Adjusting zoom and focus can be done
after the device is connected to the
network. For more details, refer to
4.3.
Adjusting Zoom and Focus
.
by rotating it
clockwise.
