Page 8
www.kpa-solutions.com
4 OPERATING DETERMINATIONS
The CAMPLIFIER 360 add on amplifier module has been specially designed for the operation
mounted INSIDE of the Kemper Profiling Amplifier (KPA).
Any operation of the CAMPLIFIER 360 outside of the KPA is forbidden!
The CAMPLIFIER 360 may be used to provide power amplification to speaker cabinets. The
signal source must be the Kemper Profiling Amplifier (KPA).
Please note that the speaker systems connected to the Camplifier must provide a
minimal
im-
pedance of
8 ohms
and must be capable of handling at least
80W
rms.
Speaker system impedances bellow 8 ohms might damage the CAMPLIFIER 360!
Speaker systems with a specified max. power handling capacity of less than 180W might
be damaged by the CAMPLIFIERs high power output!
This product is allowed to be operated with an alternating current of 230 V, 50 Hz and was de-
signed for indoor use only.
This device is designed for mobile use and for permanent installations.
By operating amplifying systems, you can produce excessive sound pressure levels that may
lead to permanent hearing loss. Please refer to the explanations under “Legal instructions”.
Please note:
operating an amplification system in public or industrial areas, a series of safety
instructions have to be followed that this manual can only give in part. The operator must there-
fore inform himself on the current safety instructions and consider them.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to ex-
treme heat, moisture or dust. There should not be any cables lying around. You endanger your
own and the safety of others!
This device must never be operated or stockpiled in surroundings where splash water, rain,
moisture or fog may harm the device. Moisture or very high humidity can reduce the insulation
and lead to mortal electrical shocks. When using smoke machines, make sure that the device
is never exposed to the direct smoke jet and is installed in a distance of 0.5 meters between
smoke machine and device.
English
