Page 6
www.kpa-solutions.com
Information on installing speaker cables
• Always treat cables carefully and protect them from damages during transportation.
• Install cables always in a structured way and protect them from damage.
• Cables must be installed in a way that no person can stumble over them. Always fix cables with an
appropriate tape.
• Both cables should be of the same kind.
• Both cables should have the same length.
• Both cables should be installed directly (no loops, S-shaped over lengths)
• Always install the cables far away from power cables (never closely parallel)
• Never put heavy objects like speaker systems, flight cases etc. on cables.
• Never wind up cables tightly around the elbow, but rather sleek with an interior diameter of 20 to 30
cm.
7.2.1 Stereo Operation
The most frequently used operating mode of the Camplifier 360 might be stereo operation, where both
channels are operated independent of each other. The highest output power during stereo operation
is achieved by connecting 8 ohms speakers. With 6 ohms speakers the output power will be slightly
reduced. For stereo operation, use both speaker pairs at the speaker output sockets and insert signal
jacks into both input sockets at the Camplifier 360.
0
8 Ω
/ 180W
Minimal
speaker impedance / power :
8 Ω
/ 180W
left
right /
mono
speaker
input
&
BlueAmps
Risk of electric shock!
Do not operate outside of KPA enclosure!
Equipment must be earthed.
Do not expose to rain or moisture!
CAMPLIFIER 360
Power
230VAC/50Hz/420VA
Fuse
0
Scheme : stereo operation
English
