Rittal Micro Data Center Level E
25
7 Operation
EN
Press the
P
key.
The
signal message appears.
Enter the new 6-digit primary code.
The
signal message appears.
Enter the new 6-digit primary code.
The
signal message appears once.
If the new primary code was not confirmed correctly with
the repeated input, the following signal message ap-
pears three times
:
Repeat the action.
Pressing the
P
and
0
key combination deletes all pro-
grammed functions (secondary code, dual code, time
delay, opening window).
Closing
Turn the key counter-clockwise until the limit is
reached.
The
/
signal message appears.
Remove the key and retain it in a safe place.
The
/
signal message appears.
Dismantle the trim piece using the auxiliary tool.
The
/
signal message appears.
Insert the drive shaft with the drilled hole forwards.
The
/
signal message appears.
Attach the bar handle (at its original position).
The
/
signal message appears.
Attach the trim piece and clip all latching points.
The
/
signal message appears.
Clear the alarm.
(This can be performed only by the primary code hold-
er in parallel mode or by the dual code holder in ordi-
nary dual code mode.) Procedure:
– Press the
ON
key.
– Press the
P
key.
– Enter the valid 6-digit primary code.
The
signal message appears.
– Press the
P
key.
The
signal message appears.
– Press the
9
key.
The
signal message appears once.
Inspection opening quick guide
Cut-out template:
7.1.3
Electronic lock for activation by an access
control system
Fig. 9:
Operating unit with electronic lock (optional)
Electronic lock (optional)
Scope of delivery / properties:
– Electronic lock with operating unit
– Input unit: Plastic, basalt grey (RAL 7012)
– Electronic release function for access control reader
units or similar peripheral release unit
– Interfaces: 1 x modular jack 4-pin (power),
1 x modular jack 8-pin (in/out) and 1 x modular jack
6-pin (input unit)
The electronic lock for activation by an access control
system provided by the customer is installed in the
Micro Data Center door. The cable for the connection to
the system is made available inside the
Micro Data Center. The power supply for releasing the
Содержание 7999.009
Страница 1: ...Micro Data Center Level E 7999 009 Operating instructions ...
Страница 37: ...Rittal Micro Data Center Level E 37 Notes ...
Страница 38: ...Notes 38 Rittal Micro Data Center Level E ...
Страница 39: ...Rittal Micro Data Center Level E 39 Notes ...
