RITE-HITE FASTRAX, Руководство пользователя

Страница: 19 / 44

PUB. NO. FASTRAXC FEBRUARY 2008 19
FASTRAX ™
MOTOR SHROUD INSTALLATION
1. Install shroud over the motor assembly, Figure 34.
CENTER SHROUD INSTALL (RADIAL ONLY)
1. Remove (6) outside screws from existing spiral track (may
need to use grip pliers to hold spacer from turning) and
fasten end brackets to the spirals,
Figure 35.
2. Remove top clamp piece from the (3) wall mount
brackets.
3. Fasten top of end wall brackets, 1 13/16" above spiral end
brackets and 1/4" to inside face of spiral. Set track into
end brackets and install top clamp piece previously
removed.
4. Measure distance from inside to inside of spiral track and
place a mark on the wall. Level track and install center
wall mount bracket on previously made center line.
5. Install center support tubes with groove facing out (using
3/8" hardware) to the end brackets on the spiral. For the
bottom tube, install top bolt only, rotate tube outward,
approx. 30° to line up install holes and temporarily insert
bolt.
6. Starting on the left side, snap top of end center shroud
piece angles into wall track, and then bottom track.
Overhang shroud end piece over spiral bracket by 1/4".
Repeat procedure until all center shroud pieces are into
the track with a minimum 2" overlap. When complete,
remove install bolt, rotate bottom support tube and install
bolt.
7. Place screws on ends and seams only to hold shroud
pieces in place.
8. Caulk from wall to wall track.
SHROUD INSTALLATION
FIGURE 34 - SHROUD
FIGURE 35 - CENTER SHROUD
Drive
Shroud
Drive Shroud Upper
Mounting Bracket
Drive Shroud
Lower Mounting
Bracket
Bottom Support
With Track
Center Shroud
Overhang End
By 1/4"
Remove
Existing Screws
Center Shroud
Wall Support
Wall Mount
Bracket
Minimum 2" Overlap
Exterior Only
Place Screws on Ends
and Seams Only
1 13/16"
1/4"
Center Shroud
Center Support
Center Shroud
End Bracket
Temp
Mounting Hole
STEP 1 STEP 2 STEP 3
STEP 4 STEP 5
Center Shroud
Angles